Type

Conference Proceedings

Authors

Dermot Brabazon
Sumsun Naher
Evans Chikarakara

Subjects

Engineering

Topics
surface roughness laser surface modification laser applications mechanical properties ti 6al 4v biomedical engineering biomedical applications materials

Laser surface modification of Ti-6Al-4V for biomedical applications (2010)

Abstract Introduction. Ti-6Al-4V is used in biomedical engineering due to its excellent properties: high strength to weight ratio, low density, high corrosion resistance and good biocompatibility. However, the use of the alloy under severe friction conditions is restricted due to poor tribological properties such as high coefficient of friction and low hardness [1, 2]. Laser surface modification is known for its improved mechanical and tribological properties for biomedical titanium alloys. The treatment produces minimal contamination and increases osseointegration [3-5]. The present study evaluated the effects of high speed, laser processing parameters on surface roughness, hardness, chemical composition and biocompatibility. Materials and Methods A 1.5KW CO2 laser in continuous mode was irradiated on flat Ti-6Al-4V samples at three levels of irradiance 15.72, 20.43 and 26.72 KW/cm2 and three levels of residence time 1.08, 1.44 and 2.16 ms. Evaluation of the surface was carried out by scanning electron microscope (SEM) examination and mechanical profilometry in accordance to ISO 4287/4288. SEM analysis of the surface topography resulting from the various laser treatments was carried out. Energy Dispersive Spectroscopy (EDS) analysis was used to determine the chemical composition of the treated areas. The effect of surface topography on cellular attachment was investigated in vitro using MC3T3-E1 pre-osteoblast cells. Cell attachment was determined using the Hoechst DNA assay and cell morphology was examined using SEM analysis. Results and Discussion An increase in residence time resulted in improved depth of processing. An increase in irradiance did not always produce an increase in depth of processing; however higher irradiance levels were found to provide for a more uniform depth of processing which reached a maximum of 80 ┬Ám. Irradiation with the scanning beam produced a single phase microstructure, see Figure 1. This single phase occurred when various constituents in the alloy have dissolved with rapid solidification thwarting segregation of the various alloying elements into high and low concentration [6]. Improved homogenous chemical composition of the laser modified region was verified by the EDS analysis. Microhardness examination revealed an increase in hardness of up to 67% after laser treatment. A relationship between irradiance and roughness was observed, roughness decreasing with increase in irradiance.
Collections Ireland -> Dublin City University -> Publication Type = Conference or Workshop Item
Ireland -> Dublin City University -> Status = Unpublished
Ireland -> Dublin City University -> Subject = Engineering: Materials
Ireland -> Dublin City University -> DCU Faculties and Centres = Research Initiatives and Centres: Materials Processing Research Centre (MPRC)
Ireland -> Dublin City University -> Subject = Engineering
Ireland -> Dublin City University -> DCU Faculties and Centres = Research Initiatives and Centres

Full list of authors on original publication

Dermot Brabazon, Sumsun Naher, Evans Chikarakara

Experts in our system

1
Dermot Brabazon
Dublin City University
Total Publications: 162
 
2
Sumsun Naher
Dublin City University
Total Publications: 56